|
|||||||||
|
|||||||||
| |||||||||
|
|
|
|
|||||||||
|
|||||||||
| |||||||||
|
|
|
| |||||||||
 |
|
|
«
Previous Thread
|
Next Thread
»
|
Thread Tools | Search this Thread | Rate Thread | Display Modes |
Tutorialized Forums Sponsor:
|
 AT&T devCentral & BlackBerry(r) Webcast Series: BlackBerry and GPS -Build Location Awareness into your BlackBerry Applications, July 10th-1:00PM EST. Register Today!
|
|
#1
September 28th, 2007, 03:55 PM
|
|||
|
|||
|
Can I turn two polygons into one
I need to bevel a part of a model but its made up of two polygons is there a way that I could make them into one so that I can bevel it.
|
|
#2
October 27th, 2007, 06:15 PM
|
|||
|
|||
|
well there are a few ways to do it so I know!
you can use the shift tool just click on the surface don't move it it will join the two not physically but when you use the bevel it will act as one or you can combine the polys and by selecting both and under detailed tab combine polygon tool simple cheers dufy
|
|
#3
October 27th, 2007, 06:25 PM
|
|||
|
|||
|
I went back and tried it. its this way
if you select both polys they can be bevelled as one. but to merge them the polys mush share points or curves if they dont weld adjacent points then select the two polys and merge them cheers dufy(motivated by creation)
|
|
| Viewing: Tutorialized Forums > 3D Graphics > Lightwave 3D > Can I turn two polygons into one |
| Thread Tools | Search this Thread |
| Display Modes | Rate This Thread |
|
|
 |
|
|
 |
|
Del.icio.us
Digg
Google
Spurl
Blink
Furl
Simpy
Y! MyWeb
Linear Mode
